Phone # 58two - 2O1 - 867four

2016 Kubota ssv75 skid steer loader. 3723 hrs and counting. AC/heat, hydraulic quick attach, 2 speed, suspension seat, auxiliary standard flow hydraulics, hand/foot controls. Weighs 8500 lbs. Starts and runs great. Runs cool while operating bush hog attachment.

Comes with 48” forks and new 78” bucket.

Won’t win first place for paint at the county fair, but is a solid machine. Galaxy beefy baby 12-16.5 tires at 90% tread. Wheel bearings are good, drive chains adjusted. Coolers washed out.

New: engine oil/filter, hydraulic oil and 2 canister filters, drive motor ( not rebuilt, NEW), chain case oil, inner and outer air filters, fuel filter.

Missing glass on sides and door. Door glass is $160 shipped. Side panels can easily be made out of a 4x8 3/16 sheet of acrylic ($85).

Fan and heat work, but AC system isn’t. Compressor spins freely. Only has 9 volts to clutch when ac turned on, so clutch not engaging. System holds a deep vacuum for half hour without creeping. Have not trouble shot it beyond this. Price goes up if someone wants me to get it operating.

Upgrades:
1)quick attach lower pin bosses with 1/2” wall thickness (factory was less than 1/8” wall).

2)Middle skid plate to 1/4”thick steel (factory barely 3/16).

3)LED headlights.

4) Auxiliary hydraulic switch has been disabled from being ECU controlled. Now has its own circuit with rocker switch on joystick operating solenoids. Much more reliable than the factory magnetic rocker switch combined with a temperamental ECU. No codes or warning lights showing.

5) Cab entry grab bars are now 3/4 solid steel. Factory were tinny hollow tubes.

All zerks take grease. Pins and bushings reasonably tight overall. Oil cap when unscrewed and put back on oil fill hole bounces around, but stays in place.

Enjoyable large frame skid steer to operate. These Kubota engines can easily be DPF and EGR deleted, then 25 extra HP added by reprogramming ECU.

Anything I’m missing feel free to ask.
Phone # 58two - 2O1 - 867four

$18k.